Advertisement
Quick Links
Advertisement
Related Manuals for Ventum NS1
Summary of Contents for Ventum NS1
- Page 2 Congratulations on your purchase of the Ventum NS1, your Aero All-Road Performance Bike! Get ready to experience a bike that is totally unlike any other on the road today. Your new Ventum NS1 combines forward thinking design with the most advanced technologies available, to shatter the notion that a road bike can be either lightweight or aerodynamic.
-
Page 3: Table Of Contents
CONTENTS FRAME DIAGRAM ..........UNBOXING ............WHEEL REMOVAL ..........SEAT POST INSTALLATION ........FRAME UNBOXING ..........WHEEL INSTALLATION ......... FINAL CHECKS & ROAD TEST ....... -
Page 4: Frame Diagram
FRAME DIAGRAM Please carefully inspect the image. It gives you a thorough break down of the names of the tubes that the frame/ fork consist of and the components that this bike uses. Please refer back to this image as needed. Top Tube Handle Bar Fork... -
Page 5: Unboxing
UNBOXING UNBOXING Remove the top tube foam blocks and shifter blocks Remove the parts box and support cover... -
Page 6: Wheel Removal
WHEEL REMOVAL WHEEL REMOVAL Remove the straps and foam blocks from the wheels Remove the wheels from the box and remove the hub guards... -
Page 7: Seat Post Installation
SEAT POST INSTALLATION SEAT POST INSTALLATION 1. Detach the seat post and remove the protective foam 2. Undo the strap around the bottom bracket... - Page 8 SEAT POST INSTALLATION SEAT POST INSTALLATION 1. Plug Di2 cable into seat post battery, you should hear a click. 2. Insert the seat post into the frame. Ensure the minimum insertion depth of 10 cm is achieved. 3. Torque the seat post clamp bolt to a minimum of 8 N.m. Temperature, moisture, and contaminants can affect the seat post clamp.
-
Page 9: Frame Unboxing
FRAME UNBOXING FRAME UNBOXING 1. Lift the frame out of the box Remove the straps from the handlebar 2. Detach the strap and foam block from the crank arm... -
Page 10: Wheel Installation
WHEEL INSTALLATION WHEEL INSTALLATION Unscrew the thru axles from the frame and fork using a 6mm hex tool Remove the spacers from the brake calipers... - Page 11 WHEEL INSTALLATION WHEEL INSTALLATION Install the wheels ensuring the rotor lines up between the brake pads Secure the wheels by re-installing the thru axles. Torque to 12 N.m. WARNING FAILURE TO FOLLOW THESE INSTRUCTIONS COULD LEAD TO SERIOUS INJURY OR DEATH.
-
Page 12: Final Checks & Road Test
FINAL CHECKS & ROAD TEST 1. Install your pedals as per the manufacturer’s instructions. 2. Check the tire pressure and inflate as per the manufacturer’s recommendation. 3. Adjust the saddle height as necessary. Ensure the seat post minimum insertion depth of 10 cm is achieved. 4. - Page 13 VENTUMRACING.COM...