Table of Contents
Advertisement
Access to the spare wheel in
the 5 seat configuration
The "steel" spare wheel is installed on
the outside, under the boot, supported
by a winch and a plastic carrier.
To gain access to the tools, refer to the
"Access to the tools" paragraph.
Fixing the "steel" spare wheel
wheels, it is normal to notice that the
washers do not come into contact
with the "space-saving" spare wheel
IX
The wheel is retained by the conical
contact of each bolt.
Removing the wheel
Open the tailgate and the lower tail-
gate (refer to the "Access" section).
Take out the handle 3 (refer to the
"Access to the tools" paragraph).
126
P R A C T I C A L I N F O R M A T I O N
Remove the plastic cover A using
the handle 3 .
Unscrew the retaining bolt B fully
using the wheelbrace 1 , to unwind
the winch cable.
Close the lower tailgate (refer to the
" Access" section).
Detach the hook C from the chain.
Unwind the winch cable fully to make
unhooking of the chain easier.
Putting the wheel back in place
Put the wheel back in place in its
carrier.
Pass the hook C into the chain.
Open the lower tailgate (refer to the
"Access" section).
Tighten the winch retaining bolt B
fully using the wheelbrace 1 .
lower tailgate and store the tools.
A , close the
Advertisement
Table of Contents
