Storing After Use; Rear Seat Belts - CITROEN C Crossover 2008 Owner's Manual

Front seat belt not fastened /
unfastened warning light
Driver's seat belt
When the ignition is switched
on, this warning light comes
on accompanied by an audi-
ble signal for a few seconds if
the driver has not fastened his
seat belt.
If the driver does not fasten his seat
belt within one minute after switching
accompanied by an intermittent audible
signal and a display on the instrument
panel display.
The warning light, the audible signal
ly 90 seconds and then return until the
driver fastens his seat belt.
If the seat belt is unfastened while the
vehicle is moving , you are alerted by
the same warnings.
S A F E T Y
Front passenger's seat belt
When the ignition is switched on, this
warning light comes on on the centre
console panel.
It is accompanied by an audible signal
for a few seconds if the passenger has
not fastened his seat belt.
If the seat belt is unfastened while the
vehicle is moving , you are alerted by
the same warnings.

Rear seat belts

inertia reel seat belt with force limiter.
Fastening
Pull the strap, then insert the tongue
in the buckle.
Check that the seat belt is fastened
correctly by pulling the strap.
Unfastening
Press the red button on the buckle.

Storing after use

Rear side seat belts
1. Pass the seat belt under the support
A located on each rear side pillar,
2. Insert the tongue in the slot B of the
support.
Rear buckles
Store the buckles in the locations A
and B provided for this purpose in
the rear seat cushion.
VI
103