5 Reading out the RFID transponder
5 Reading out the RFID transponder
1. Press the On/Off key 4 on the CONEXO pen.
ð The CONEXO pen has been switched on.
ð LED 1 flashes.
2. Connect the CONEXO pen to the tablet.
ü The user finds themselves in a menu within the CONEXO
app where a scanning operation is requested.
3. Hold the CONEXO pen directly against the RFID chip of a
component or functional location and press the scan key
8.
ð If an RFID chip has been scanned correctly, the LED 7
turns green.
ð If an RFID chip has not been scanned correctly, the LED 5
turns red.
ð An audible signal is emitted during a correct scan process.
ð The data that is read out is transferred to the CONEXO
app.
4. Scan as many components as required.
5. Hold down the On/Off key 4 for at least three seconds.
ð The CONEXO pen has been switched off.
GEMÜ 658
6 Intended use
Danger of explosion!
▶ Risk of severe injury or death.
●
●
Improper use of the product!
▶ Risk of severe injury or death
▶ Manufacturer liability and guarantee will be void
Only use the product in accordance with the operating
●
conditions specified in the contract documentation and in
this document.
The product is designed for installation in piping systems and
for controlling a working medium.
1. Use the product in accordance with the technical data.
2. Follow the supplement according to ATEX, provided that it
was ordered in accordance with ATEX.
44 / 76
DANGER
Do not use the product in potentially
explosive zones.
Only use the product in potentially ex-
plosive zones confirmed in the declara-
tion of conformity.
WARNING
www.gemu-group.com