Table of Contents
Advertisement
Hawk 2 Family Installation Guide, Rev. C
Safety instructions
1. The disc drive(s) are to be installed in a customer
supplied enclosure where the surrounding air does
o
not exceed 50
C.
2. Four (4) 6-32 UNC-2A screws are required for
installation. Maximum screw length into side of
drive is 0.15 inches (3.81 mm). Maximum screw
length into bottom is 0.20 in. (5.08 mm). Maximum
screw tightening torque is 8.0 in-lb (0.90 NM) with
minimum thread engagement of 0.12 in. (3.0 mm).
3. The power requirements are shown in Section 1.0
Product Information.
4. The power supply must satisfy the safety require-
ments for SELV (Safety Extra Low Voltage) cir-
cuits.
5. Service is to be provided by trained Seagate ser-
vice personnel.
6. The incorporation of the disc drives listed in this
guide into a customer enclosure must meet the
appropriate safety requirements of the country in
which it is used (e.g. UL 1950, CAN/CSA-C22.2
No. 950-M89, DIN VDE 0805/05.90 and EN60950:
1988 (IEC 950).
5
Advertisement
Table of Contents
