Figure 80. Installing the E3.s drive into the drive carrier
Next steps
1.
Install the drive
carrier.
Examax connector
Removing the left examax connector
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove all the sleds from the
4.
Remove the 60 mm fan
Steps
1. Disconnect the examax cable from the backplane.
2. Using the Phillips 1 screwdriver, remove the screws that secures the examax connector to the enclosure.
3. Lift the examax connector out of the enclosure.
Safety
instructions.
Before working inside your
enclosure.
cage.
system.
Installing and removing system components
77