Next steps
1.
Replace the power supply
2. Follow the procedure listed in
Chassis management board
This is a service technician replaceable part only.
Removing the chassis management board
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the power supply
4.
Remove the power interposer
5. Disconnect all the cables that are connected to the chassis management board.
Steps
1. Using the Phillips 2 screwdriver, remove the screws securing the midplane power cables to the chassis management board.
Figure 58. Removing the midplane power cables from the chassis management board
2. Using the Phillips 2 screwdriver, remove the two screws securing the chassis management board to the chassis.
3. Slide the chassis management board toward the front of the system to disengage the board from the connector and lift the
board from the system.
units.
After working inside your system
Safety
instructions.
Before working inside your
units.
board.
system.
Installing and removing system components
59