Installing The Chassis Management Board - Dell PowerEdge C6600 Installation And Service Manual

Figure 59. Removing the chassis management board
Next steps
Replace the chassis management

Installing the chassis management board

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the power supply
4. Remove the power interposer
5. Disconnect all the cables that are connected to the chassis management board.
Steps
1. Insert the chassis management board into the system, aligning the guide slots with the standoffs on the chassis.
2. Push the board toward the rear of the system to connect the board to the connector in the system.
3. Using the Phillips 2 screwdriver, tighten the screws to secure the board to the chassis.
60 Installing and removing system components
board.
Safety instructions.
Before working inside your
units.
board.
system.