Cleaning Carpets - Dirt Devil SM11 User Manual

USING YOUR STEAM CLEANER
WARNING: Danger of scalding

CLEANING CARPETS

IMPORTANT:
Never use the steam mop without a cleaning pad attached to the mop head. Never
leave the steam mop on one spot for an extended period of time or with a damp or wet microfibre mop
pad attached as this may damage the floor surface.
1. Place the microfibre mop pad on the floor with the tab side facing up. Place the mop head onto the
microfibre mop pad making sure the pad covers the entire mop head.
2. With the microfibre mop pad attached, push the mop head into the front of the carpet glider. Then place
the back of the mop head into the clip. The carpet glider should only be used when refreshing carpets.
3. Plug the steam cleaner into the mains. The blue light will illuminate to indicate power on. The green light
will illuminate to indicate that the steam cleaner is ready to use.
4. Place your foot onto the mop head and pull the handle backwards to recline.
5. To produce steam, squeeze the trigger in short bursts. Don't hold the trigger continuously to prevent
overwetting floors.
6. Move the steam cleaner slowly backwards and forwards across the carpet paying particular attention to
high traffic areas. Squeeze/release trigger as required.
7. To release the carpet glider, place your foot on the clip and push down. Lift the steam cleaner to remove it.
Tip: If the area you are cleaning is becoming too wet, squeeze the trigger in short bursts.
1
1
5
1 1
2 3
6 7
1
4
USER MANUAL 11