Table of Contents
Advertisement
Semi-Automatic Electric Foreman DB110 Operation
ADJUSTMENTS (Cont')
Swing Stops
(Fig. 10A)
Two Swing Stops are provided to assist in drilling pocket holes in the
same location on multiple workpieces of the same dimension. When
the Swing Stop is not used, it will pivot out of the way to allow the
workpiece to slide underneath and rest against the fence. To change
the location of the Swing Stop simply loosen the knob, move to the
new location and tighten the knob to lock the Swing Stop in position.
Changing the Drill Bit
(Fig. 10B & 10C)
IMPORTANT! Before changing the Drill Bit, make certain your ma-
chine is DISCONNECTED from the ELECTRICAL SUPPLY. Without an
electrical supply you can be certain the Drill Bit will not accidentally
engage while you are performing this adjustment.
1. Disconnect the machine from the electrical supply.
2. Remove the Black Acrylic Top to gain access to the inside
of the machine.
3. Lift the Tool Plate as it pivots on the hinges till the Safety Latch
engages to hold the Tool Plate in position.
4. Remove the Clevis and Cotter Pin from the Connecting Rod to
disconnect the Connecting Rod from the Motor Mount.
5. Remove the Hairpin Clips from the ends of the Guide Rods and
remove the Drill Motor and Motor Mount assembly.
NOTE: Now is a good time to clean and lubricate the Guide Rods
according to the "MAINTENANCE" section of this manual.
6. Loosen both Set-screws with the hex key that hold the Drill Bit in
place inside the Dill Adapter.
7. Insert a new or re-sharpened Drill Bit into the Drill Adapter, aligning
the flats on the Drill Bit shank with the set-screws in the Drill
Adapter.
8. Tighten the set-screws front and back to maintain equal pressure
on the Drill Bit shaft.
9. Re-install the Drill Motor and Motor Mount assembly on the Guide
Rods. Push the Hairpin Clips back on the grooves located on the
ends of the Guide Rods.
10. Connect the Clevis and Cotter Pin through the Connecting Rod
and Motor Mount.
11. Lift the Tool Plate to disengage the Safety Latch and lower the
Tool Plate into position.
12. Check the Drill Bit Depth Stop settings for the material thickness
being drilled.
13. Place the Black Acrylic Top back on the machine.
DB110 Electric - Adjustments
Adjust the Swing Stop to locate the material
for repetitive drilling.
Disconnect the Connecting Rod and Hairpin Clips to
remove the Electric Drill Motor from the Guide Rods.
The Drill Bit is held in position with set-screws
in the Drill Adapter.
10.
Fig. 10A
Fig. 10B
Fig. 10C
Advertisement
Table of Contents
