Wiznet WizFi630 Manual page 67

Hide thumbs Also See for WizFi630:

Table of Contents

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions may cause harmful interference to radio

communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

-Consult the dealer or an experienced radio/TV technician for help.

WARNING: This equipment may generate or use radio frequency energy. Changes or

modifications to this equipment may cause harmful interference unless the modifications are

expressly approved in the instruction manual. The user could lose the authority to operate

this equipment if an unauthorized change or modification is made.

This device complies with Part 15 of the FCC rules. Operation is subject to following two

conditions: 1. this device may not cause harmful interference and 2.This device must accept

any interference received including interference that may cause undesired Operation of this

device.

The changes or modifications not expressly approved by the party responsible for Compliance

could void the user's authority to operate the equipment.

To comply with the FCC RF exposure compliance requirements, this device and its antenna

must not be co-located or operating to conjunction with any other antenna or transmitter,

except if installed in compliance with FCC Multi Transmitter procedures.

To inherit the modular approval, the antennas for this transmitter must be installed to

provide a separation distance of 20cm from all persons and must not be co-located or

operating in Conjunction with any other antenna or transmitter.

Table of Contents