Qualcast QGTP25 Original Instructions Manual page 17

7. Run the machine for 30 seconds at idle speed, clutch lock-off lever and throttle lever at
the same time.
8. Adjusting line length while working:
9. This machine is fitted with a 'Tap & Go' head.To release more line, tap the cutting
line head against the ground with the engine at top speed, the line will be released
automatically and the knife will cut off the excess length.
If you experience any problems, turn off the engine and the machine will stop running. To
stop the cutting head, release the throttle lever.
The further you push the throttle lever, the higher the motor speed. When releasing the
throttle lever, the motor becomes idle and the cutting tools will stop.
If the machine is hot, the choke level can be adjusted to
the machine.
NOTE: If the engine does not start up after several attempts, refer to the section
'Troubleshooting'.
NOTE: Always pull the starter cord out in a straight line. If it is pulled out at an angle,
friction will occur on the eyelet. As a result of this friction, the cable will become frayed and
will wear away faster. Always hold the starter handle when the cable retracts. Never allow
the cable to snap back when it has been pulled out.
NOTE: Do not start the motor in tall grass.
position directly when restart
17