Qualcast QGTP25 Original Instructions Manual page 12

Mounting the shaft
Push the lower part of the shaft (b) right down until the stop pin (a) slots into the hole (c) in
the shaft. This is easier to do if you rotate the bottom of the shaft (b) slightly in both direc-
tions. The pin (a) is in place when it is completely lodged in the hole. Lastly, tighten the
knob (d) securely.
b
Assembling the safety guard
Remove the screws from the cutting head holder.
Assemble the safety guard and tighten the screws using the accessory provided.
12
a
c
d