Appendix B: Gas Specifications - Blue Sea EVOLUTION G47 Service Manual

B

Appendix B: Gas Specifications

Gas Specifications
- Australia
Main Burner Injectors
Pilot Burner Injectors
Low Fire Screw
High Fire Screw
Supply Pressure
Burner Operating Pressure (*)
Gas Regulator Cap Screw
- New Zealand:
Main Burner Injectors
Pilot Burner Injectors
Low Fire Screw
High Fire Screw
Supply Pressure
Burner Operating Pressure (*)
Gas Regulator Cap Screw
- UK Only:
Category:
Flue Type:
Main Burner Injectors
Pilot Burner Injectors
Low Fire Screw
High Fire Screw
Supply Pressure
Burner Operating Pressure (*)
Gas Regulator Cap Screw
NOTE: (*) Measure burner operating pressure at upper test point (Supply Pressure) on gas control valve located behind
control panel, this is to be carried out with burner operating at 'High Flame' setting. Operating pressure is
ex-factory set, through appliance regulator and not to be adjusted, apart from when carrying out gas conversion, if
required. Refer to 'Gas Conversion and Specification' Section for further details.
Blue Seal Evolution Series - G47 Gas Pasta Cooker
Amendment 6
Natural Gas.
Ø 3.10mm
0.62
Ø 1.55mm
Fully Out (c.c.w.)
1.13 - 3.40 kPa
0.92 kPa
Natural Gas.
Ø 3.10mm
0.62
Ø 1.55mm
Fully Out (c.c.w.)
1.13 - 3.40 kPa
0.92 kPa
II
2H3P.
A
1.
Natural Gas (G20)
Ø 3.10mm
0.62
Ø 1.55mm
Fully Out (c.c.w.)
20 mbar
9.5 mbar
LP Gas (Propane)
Ø 1.90mm
0.35
Ø 1.55mm
Fully Out (c.c.w.)
2.75 - 4.50 kPa
2.6 kPa
LP Gas
Ø 1.90mm
0.35
Ø 1.55mm
Fully Out (c.c.w.)
2.75 - 4.50 kPa
2.6 kPa
Propane (G31)
Ø 1.90mm
0.35
Ø 1.55mm
Fully Out (c.c.w.)
37 mbar
27.7 mbar
32
© Copyright Moffat Ltd, March 2016