6
Service Procedures
6.2.2
Pilot Injector
1.
Remove ignition electrode.
2.
Disconnect pilot supply tube from pilot burner by
unscrewing nuts and olive.
3.
Remove pilot injector, and clean or replace as necessary.
Pilot Burner
Figure 6.2.3
NOTE:
Ensure correct size injector is used (refer
Specifications section).
4.
Re-assemble in reverse order.
6.2.3
Pilot Burner
1.
Disconnect the thermocouple and / or the piezo electrode
from the pilot burner.
2.
Disconnect pilot supply tube from pilot burner by
unscrewing nut and olive.
3.
Remove screw securing the pilot burner to front of the
pasta cooker, and remove pilot burner assembly.
Piezo Electrode
Figure 6.2.4
4.
Replace pilot burner and re-assemble. Ensure correct
pilot injector is re-fitted (refer to the Specifications
Section).
Blue Seal Evolution Series - G47 Gas Pasta Cooker
Amendment 6
6.2.4
1.
2.
3.
4.
5.
6.2.5
1.
2.
Thermocouple
18
Safety Cut-Out Thermostat
Drain water from pasta cooker.
Remove control panel (refer 6.2.1 )
Disconnect safety cut-out leads from interrupter on the
thermocouple.
7
Using
/
" tube spanner, remove the safety cut-out
8
thermostat from fryer tank.
Safety Cut-Out
Figure 6.2.5
Replace and re-assemble in reverse order, using sealant
suitable for 115°C on threads (Loctite 567
recommended).
Main Injector
Unscrew injector out of injector mounts.
Remove injector, and clean or replace as necessary.
Ensure correct size of injectors are refitted (refer
Specifications Section).
Main Injector
Figure 6.2.6
© Copyright Moffat Ltd, March 2016