Table of Contents
Advertisement
B = the angle of the side plate
The angle must also be maintained for all knives. For irregular angles, the chain is run irregularly, wear quickly
and break down prematurely.
Since these requirements can only be met with sufficient and regular exercise:
•
A File Holder must be used when sharpening the saw chain by hand. The correct filing angle marked on it.
•
Hold the file horizontally (at a right angle to the guide rail) and file according to the angle mark on the file
holder. Support the file holder on the top plate and depth gauge.
•
File down. The knife is always from the inside to the outside
•
The file sharpens only in forward motion. Lift it off in the backward motion.
•
Do not touch the dynamic links with the file.
•
Turn the file regularly continue to avoid a one-sided wear.
All knives must have the same length, otherwise they will also vary. As a result, the chain is irregular and it
increases the risk of going broke.
Lubricate the drive, pole pruner
Lubricate the drive every 10 to 20 operating hours.
•
Apply the grease gun to the grease nipple Fig .54 (Q).
•
Squeeze some grease into it.
Attention! Fill only a small amount of grease. Do not overfill.
Check the hedge trimmer for obvious faults such as:
•
Loose attachments
•
Worn or damaged components
•
Bent, broken or damaged cutting tools
•
Correctly attached and working covers and safety devices
•
Wear, in particular, cutting tool play
Immediately replace damaged or blunt cutting tools, even in the event of minor damage.
Oiling the gears
Oil the gears every 10 to 20 operating hours.
•
Position the grease gun at the lubricating nipples.
•
Insert some grease.
•
Attention! Fill only a small amount of grease. Do not overfill
•
Oil the cutting tools and the angle adjustment with environmentally friendly lubricant.
Setting the idle speed
If the cutting tool is still moving when the device is in idle, change the idle speed.
•
Let the motor warm up for 3-5 minutes (not at high speed!).
•
Turn the adjusting screw (S):
-
Clockwise: The idle speed will increase (+)
-
anti-clockwise: The idle speed will decrease (-)
The idle speed is 3000 min-¹ .
Contact the manufacturer if the cutting tool still continues to move in idle. Do not continue working with the
tool!
Wear Parts
Even when used in the intended way, some components are subject to normal wear. They must be
replaced depending on the kind of duration of usage. These parts include, among others, the cutting tool
and the retaining disk.
Warning! Use only original manufacturer 's replacement parts, accessories and attachments. Failure to
do so can cause poor performance, possible injury and may void your warranty.
Due to security reasons please see to it that the equipment is sent back free of oil and gas!
30
Advertisement
Table of Contents
