Table of Contents
Advertisement
before starting the engine.
Stay clear of other workers or bystanders by at least 15 meters.
Whenever approaching an operator of the machine, carefully call his attention and confirm that the
operator stops the engine. Be careful not to startle or distract the operator which can cause an unsafe
situation.
Never touch the nylon cutting head or blade whenever the engine is running. If it is necessary to replace
the protector or cutting attachment, be sure to stop the engine and confirm that the cutting device has
stopped running.
The engine should be turned off when the machine is moved between work areas.
Be careful not to hit the nylon cutting head against stones, or the ground.
Unreasonable rough operation will shorten the life of the machine as well as create an unsafe
environment for yourself and those around you.
Pay attention to loosening and overheating of parts. If there is any abnormality of the machine, stop
operation immediately and check the machine carefully. If necessary, have the machine serviced by an
authorized dealer. Never continue to operate a machine which may be malfunctioning.
In start-up or during operation of the engine, never touch hot parts such as the muffler, the high voltage
wire or the spark plug.
After the engine has stopped, the muffler is still hot. Never place the machine in any places where there
are flammable materials (dry grass, etc.), combustible gasses or combustible liquids.
Pay special attention to operation in the rain or just after the rain as the ground may be slippery.
If you slip or fall to the ground or into a hole, release the throttle lever immediately.
Be careful not to drop the machine or hit it against obstacles.
Before proceeding to adjust or repair the machine, be sure to stop the engine and detach the spark plug.
When the machine is placed in storage for a long time, drain fuel from the fuel tank and carburettor, clean
the parts, move the machine to a safe place and confirm that the engine is cooled down.
Make periodic inspections to assure safe and efficient operation. For a thorough inspection of your
machine, please contact a dealer.
Keep the machine away from fire or sparks.
It is believed that a condition called Raynaud's phenomenon, which affects the fingers of certain
individuals, may be brought about by exposure to vibration and cold. Loss of colour and numbness in the
fingers. The following precautions are strongly recommended because the minimum exposure which
might trigger the ailment is unknown:
- Keep your body warm, especially the head, neck, feet, ankles, hands and wrists.
- Maintain good blood circulation by performing vigorous arm exercises during frequent work breaks
and by not smoking.
- Limit operating hours to avoid prolonged exposure to the tool.
- If you experience discomfort, redness and swelling of the fingers followed by whitening and loss of
feeling, consult your physician before further exposing yourself to cold and vibration.
Always wear ear protection, loud noise for long time can make hearing debase even lost hearing.
Total face and head protection must be wearing to prevent damage from plummet or branch.
Wear no-slip heavy duty work gloves to improve your grip on the brush cutter handle. Gloves also reduce
the transmission of machine vibration to your hands.
WARNING: The cutter area is still dangerous while the machine is coasting to a stop.
When transport, this unit must be handled carefully. Do not expose yourself or others to danger.
Envelop the blade before storage. Keep children away from it.
Never remove the machine's guard.
Clean and maintain the tool before storage (see the chapters on this manual). Bring maintenance after
each use according the instructions of this manual. Improper maintenance can reduce the lie of the tool,
bring bad results and wear the tool and its accessories.
Check the tool before and after use. Check for loose fasteners, fuel leaks and damaged parts, such as
10
Advertisement
Table of Contents
