Table of Contents
Advertisement
c. Assemble the handle
•
Install the front handle as shown on the image.
•
Make sure that you align the pin with the hole. Tighten the screws only loosely before you have the
most comfortable working position set to the risers.
d. Assemble the carter of protection (grass trimmer and brush cutter)
•
On the brushcutter/grass trimmer tube, place the carter of protection on its support.
•
Screw the carter of protection with the 4 screws provided.
Warning! For brushcutter and grass trimmer operation, never use the machine without the
guard assembled!
e. Blade for brushcutter
- Align the two holes of the flange and the pin.
- Use a tool to hold the flange. Loosen the nut, use a wrench if necessary.
- Then remove the bell and the outer flange. Place the blade (17) on the tool, then replace the outer
flange (17b) and the bell (17a).
- Tighten the nut.
19
Advertisement
Table of Contents
