Installation; Horizontal Adjustment - Modena WT 1120 UFWH User Manual Book

PART 3: INSTALLATION GUIDE

Installation

•
The appliance should not be installed in an environment below 0°C.
Do not install or place the washing machine outdoors.
• Leave some space at least 10 cm between the appliance and the
surrounding objects or wall
•
Place the appliance on a sturdy flat surface
•
Keep the appliance away from hot objects and water splashes.
•
If there are many insects in the installation environment, please keep
the surroundings of the washing machine clean. The warranty does
not cover any damage caused by cockroaches or other insects.
•
The appliance is equipped with anti-rat cover to protect the
appliance from small animals like rats infiltration. Install the anti-rat
cover on the bottom base of the appliance
•
When installing the appliance,
remove all packaging and the tub
support base as shown in the
picture. Failure to do so will
hinder the appliance performance
•
During first installation or first
use, residual water may come out
of the appliance. This is normal
because the appliance was pre-
tested in factory

Horizontal Adjustment

•
Adjust and level the appliance to prevent noise and vibration. Install
on a sturdy flat surface (recommended place is on the corner of the
room).
•
If the surface is not flat, adjust the feet (do not insert foreign object
such as a block of wood under the feet). Ensure that the appliance
is level by using a leveling measurement device
•
Adjust the feet until the appliance is level and lock the feet by
tightening the nut
•
Do not place the appliance on top of a desk to prevent the appliance
from falling down
8
Tub support
Base packing