Table Of Content Part 1: Installation Bottom Cover Installation Outer Drain Hose Installation Placing The Washer Accessories Part 2: Understanding Control Panel Part 3: Preparation Before Washing Part 4: Troubleshooting Part 5: Maintenance Part 6: Specification Appendix 1: International Textile Care Label Appendix 2: Helpful Instructions In Removing The Stain...
PART 1: INSTALLATION Bottom Cover Installation Lean the back of washer forwards a bit, push the bottom to end from he groove of pedestal. 2. Fix the bottom board to the pedestal of washer by screw. Bottom Board Outer Drain Hose Installation Spring Insert the outer drain hose into the Ring...
PART 2: UNDERSTANDING CONTROL PANEL A (Power) Press this button to switch on and off washing machine. B (Program) • STANDARD: This Indicator light will ignite during washing, rinsing, and spinning. • BIG OBJECT: This program is for washing big, thick, and dirty laundry.
Page 5
• WASH: This program is standard program for washing. • RINSE: This program is to rinse clothes. • SPIN: Spin is required after laundry is being washed. C (Start/Pause) Press this to start the operation after power is connected and this button also serves to pause the operation and press it again to restart operation.
PART 3: PREPARATION BEFORE WASHING 1. Installation Method of Intake Hose • Align screw thread of connector with screw thread of tap bore. • Switch connector tightly to make rubber tap press tightly on the tap bore until it is completely prevented from water leaking.
Page 7
2. Turn on the tap with pressure (0.03~0.6MPa) Bad installation of quick joint will cause water-leaking, please check: Whether the flat surface of tap bore is plain or not. 2. Have the four screws been switched tightly? 3. The socket must be safely earthed, then connect the wire.
Page 8
Don’t forget to take out coin and key or etc. from the pocket before washing to avoid damaging clothes and tub. 2. Clothes should be classified and then wash them separately. 3. When washing good quality clothing or with fuzz, please put clothes inside nylon net bag.
PART 4: TROUBLESHOOTING When something goes wrong with the washer, unplug the washer. Check whether there is any problem below: PROBLEM POSSIBLE CAUSES DIGITAL SOLUTIONS OF BREAKING SCREEN DOWN • Water inflow • Control unit • Increase water overtime(30min), small breakdown.
Page 10
• Drain hose • Wire not well press start/ bending/flatten/twisted. connected. pause button • • Control unit Melt the breakdown. ice/clean the jam then press start/pause button • Smooth the drain hose then press start/pause button • Water level self- •...
Page 11
There is a pause after wash and spin Extended draining program sets by process program Tub rotates on and off when spinning Intermission spinning is set to achieve begins the better spinning effects Water fed and rinsed may occur during During spinning, unbalanced laundry is spinning being automatically put right...
PART 5: MAINTENANCE Don't put it in a damp place like Don't place the washer Don't expose the washer in bathrooms or wash it with water nearby the fire or heat the sun or rain or put it near or put wet clothes on it, sources.
PART 6: SPECIFICATION MODEL WT 1121 WAM Type Single tub Wash Capacity 11 kg Spin Capacity 11 kg Rated Washing Power 560 W Rated spin power (W) 440 W Glass Top Lid Number of Programs Two Water Inlet Yes (with pump)
APPENDIX 1: INTERNATIONAL TEXTILE CARE LABEL Notice the wash code symbols on attached clothing labels. In taking care of your clothes, preferably before washing by the machine, you need to pay attention to the wash code symbols on the label attached to your clothing, the description is outlined below: Washing Normal wash action...
Page 15
cleaning Dry cleaning with all with besin, pure abstergents alcohol R111 cleaning with perchloride, petrol, pure alcohol, R111 clean and R113 Drying Drying with machine dryer Drying by stretched high temperatures Drying with Drying swing machine dryer temperature Drying using hangers clothing using the dryer...
APPENDIX 2: HELPFUL INSTRUCTIONS IN REMOVING THE STAIN Stain removal instructions below are approximate and can only be used on clothing / materials that can be washed. Alcoholic Beverages: Clean up material with water first, then use the liquid and rinse water-glycerin with a vinegar-water liquid.
Page 17
Chewing Gum: Harden the gum stains by putting ice on it. Then wash the stain carefully. Moss: Do not let stains moss materials for too long. Put the clothes into the cold water for a few moments, rub with detergent, and rinse with warm water.
Page 18
Grass stain: Rub stain with detergent. If possible, use bleach. For wool, use alcohol for good results. Oil / Fat Stain: Scrub the stain with detergent and rub it. Then, wash the material with warm water. Paint : Use paint thinner to remove the stain. Put on cotton wool.
Need help?
Do you have a question about the WT 1121 WAM and is the answer not in the manual?
Questions and answers