BakerStone B-AJLXX-O-000 Product Manual page 17

Keep the appliance area clear and free from combustible materials, gasoline, and other flammable
vapors and liquids.
Do not obstruct the flow of combustion and ventilation air.
fasteners
Figure-14
Figure-15
Step 1. Working with a completely cooled appliance, turn off the LP
gas cylinder valve and disconnect the LP gas cylinder from the
appliance.
Step 2. Remove the Pizza Oven Box or griddle from the top of the
appliance [see Figure-13].
Figure-13
Step 3. Locate the fasteners attaching the Burners to the Burner
Support bracket. Remove these fasteners [see Figure-14].
Step 4. Lift the Burners up and towards the rear of the appliance to
remove slowly, taking care not to damage the gas valves. The gas
valves are hidden between the firebox and control knobs. The
burners should come out freely [see Figure-15]. Then disconnect
the ignition wire from ignitor.
Step 6. Clean the outside surfaces with a stiff brush to remove any
debris or dirt.
Step 7. Clean the inside of the Burners by inserting a stiff wire or
small bottle brush into the inlet of the Burner. Compressed air may
also be used to clean the burners by blowing air into the inlet
portion of the burner and the air will flow out of the venture holes.
Step 8. Reconnect the ignitor wire and replace the burners by
carefully inserting the Burners back into the firebox, taking care to
avoid damaging the gas valves and orifices when installing.
16