Lp Gas Cylinder Connection - BakerStone B-AJLXX-O-000 Product Manual

-New LP gas cylinders must be purged prior to filling.
-DO NOT allow the cylinder to be filled beyond 80% capacity. Over-filled LP gas cylinders can create
a dangerous condition. Over-filled LP gas cylinders can build-up pressure and cause the relief valve
to expel propane gas vapors. The vapor is combustible and if it comes in contact with a spark
source or flame an explosion causing severe burns, bodily harm, or death could occur.
-Always use a protective cylinder cap when grill is not connected to the gas cylinder.
-Inspect the LP gas cylinder valve rubber seal for cracks, wear or deterioration prior to use. A
damaged rubber seal can cause a gas leak, possibly resulting in an explosion, fire or severe bodily
harm.
Spare LP Gas Cylinder
-Do not store a spare LP gas cylinder under or near the appliance.

LP gas cylinder connection

Figure-1
Burner Control Knob
WARNING:
The pressure regulator and hose assembly supplied with the appliance must be used. Replacement
pressure regulators and hose assemblies shall be those specified by the appliance manufacturer.
Storage of this appliance indoors is permissible only if the cylinder is disconnected and removed
from the appliance.
Step 1. Ensure the LP cylinder used conforms to the requirements
listed on the previous page. Also inspect the LP gas cylinder valve
rubber seal for deterioration such as cracks, deformation or tears.
Step 2. Inspect the LP gas cylinder valve to ensure the threads
match that of the included hose and regulator.
Step 3. Ensure all the burner control knobs are in the OFF position.
See Figure-1, Burner Control Knob.
Step 4. Thread the included hose and regulator onto the LP gas
cylinder. Turn the coupling fastener clockwise by hand until it stops.
WARNING: Do not use tools to tighten the coupling fastener.
9