Lp Gas Cylinder Placement; Lighting Instructions - BakerStone B-AJLXX-O-000 Product Manual

LP Gas Cylinder Placement

Figure-6

Lighting Instructions

Figure-7
MATCH LIGHTING
If the appliance does not light using the stops above a match may be used to light the appliance.
Figure-8
HOW TO TURN OFF APPLIANCE:
Ensure the LP Gas Cylinder is placed at least 24in (61cm) away from
the appliance on a level and stable table surface [see Figure-6].
Take care to place the LP Gas Cylinder where it will not present a strip
hazard.
WARNING: Read and follow all instructions and warning listed on prior
pages before attempting to use the appliance.
Step 1 Check that the control knob is in the
Step 2 Turn on the gas tank valve.
Step 3 Press and turn the knob slowly to
light within three attempts.
Step 4 If burner does not light, turn the knob to
then repeat step 3.
Step 5 Once burner is lit, adjust the flame as desired between
Step 1. Turn on the gas tank valve.
Step 2. Attach a match to the lighting rod and light the match.
Step 3. Insert the match through the side of the firebox towards the
burner [see Figure-8] and immediately turn the burners to
Step 4. Burner should light immediately. If the burner does not light,
turn off the burners and gas valve on the tank wait 5 minutes before
trying again.
Step 1. Step 1 Rotate control knob to
Step 2. Turn off the gas supply.
WARNING: Turn off and disconnect gas supply when not in use.
12
position.
position. The burner should
, wait 5 minutes and
and
position [see Figure-7].
.
.