Inserting The Cassette Tape When The Outside Panel Is Removed; Cleaning When The Heads Are Clogged; Cleaning By Cleaning Tape - Sony BETACAM SX DNV-5 Maintenance Manual

1-11. Inserting the Cassette Tape when the Outside Panel is Removed

1-12. Cleaning when the Heads are Clogged

1-12-1. Cleaning by Cleaning Tape

1-11. Inserting the Cassette Tape when
the Outside Panel is Removed
1. Place the cassette compartment into the up state.
(Refer to section 1-7.)
2. Insert a cassette tape in the cassette compartment.
3. Insert a screwdriver into the hole of cassette compart-
ment shown in the figure, move it in the direction
indicated by the arrow until it locks into place.
n
Never push the lid arm (L) when placing the cassette
compartment into the down state.
The lid arm (L) become deformed, and the front cover can
not be locked when the outside panel is installed.
Lid arm ( L )
Hole of the cassette
compartment
Cassette compartment
1-28
Screwdriver
1-12. Cleaning when the Heads are
Clogged
If the video heads are clogged, clean the heads as the
following procedure.
If the video heads are still clogged after cleaning by the
cleaning tape, clean them by cleaning cloth.
1-12-1. Cleaning by Cleaning Tape
n
Make sure to use the cleaning tape BCT-5CLN. If clean-
ing is performed by other kind of cleaning tape, unusual
wearing or damage of the video heads, may occur.
1. Insert the cleaning tape BCT-5CLN in the unit.
2. Press the PLAY button.
Head cleaning starts.
3. After 5 seconds, press the EJECT button.
4. The cleaning tape will be eject.
n
Be sure to take out the cleaning tape after cleaning to
avoid damages to the heads.
5. Confirm that the head clog is clear.
DNV-5