Sony BETACAM SX DNV-5 Maintenance Manual page 21

Handle
Loosen the three screws fully and remove the handle.
(Stoppers are provided for these screws.)
Front Lid
Loosen the two screws fully and remove the front lid.
(Stoppers are provided for these screws.)
n
Insert the rib of the front lid firmly into the groove during
installation.
Outside panel
1. Remove the front lid.
2. Loosen the four screws fully and remove the outside
panel.
(Stoppers are provided for these screws.)
n
Insert the hook section of the outside panel firmly into the
guide shaft of the cassette compartment during installation.
Inside Panel
1. Loosen the four screws fully and open the inside panel
in the direction indicated by the arrow.
(Stoppers are provided for these screws.)
m
. Be careful not to bend the two flexible wires intentional-
ly.
. When opening, hook the inside panel on the protection
cover of connector box to avoid damage to the cabinet.
2. Disconnect connectors CN27 and CN30 on the MB-
627 board.
3. Remove the flexible card wires from connectors
CN101 and CN102 on the TC-80 board.
(Refer to section 1-15.)
4. Disconnect connector CN701 on the SW-882 board,
remove the harness from the shield plate on the inside
panel.
5. Remove the two hinges.
DNV-5
Connector Box
Removal
1. Remove the front lid, outside panel, and inside panel.
2. Loosen the four screws fully and remove the bottom
cover.
(Stoppers are provided for these screws.)
3. Remove the four screws, then remove the connector
box.
Screws (B3 x 8)
Tighitening torque
-2
80 x10 N.m
(8.1 kgf.cm)
Connector box
4. Disconnect connectors CN104 and CN105 on the
CNB-1 board , and connecter CN1 on the CT-185
board.
MB-267 board
CN20
CN104
Cautions during Installation
1. Connect the connector CN20 on the MB-627 board
securely to the connector CN101 on the CNB-1 board
in the connector box.
2. Connect the connectors CN104 and CN105 on the
CNB-1 board, and connector CN1 on the CT-185
board and connecter CN1 on the CT-185 board, after
attaching the connector box to the unit.
3. Be careful not to get caught the harness in the rib.
1-6. Removal/Installation of Cabinet
Screws
Bottom
cover
Screws
Screws (B3 x 8)
Tighitening torque
80 x10 -2 N.m
(8.1 kgf.cm)
CN1
CN105
CN101
CNB-1 board
Hole
1-15