Menu Operation - Denver DFT-1942 User Manual

Menu Operation

Basic TV operation
TURN ON LCD TV
1.Connect power cable to mains supply and turn on the power by using the " Switch" at the back.
The standby indicator on the front of the TV will light up in red.
2.Press the POWER button on the top of the TV to turn on, the indicator will turn green.
TURN OFF LCD TV
Press the POWER button on the top of the TV or on the handset to turn the TV off into standby mode,
the standby indicator will turn red.
NOTE: When you initially use the TV, you will see the "First Time Installation" menu as below:
You can select "Country" and "Language"(OSD
display laguage), and select the contents of the
Auto Search(Analog Program or Digital Program)
accroding to the hints on the bottom.
When you finished, press ↑↓button to select "OK",
and press OK button to start auto serch.
The TV will start searching from the lowest
frequency(You can press MENU to cancel
the auto search.). When it finds a station, it will
automatically store this in the first location and
move to the next. When Autosearch is complete,
the TV will display the first station found.
If you want to change the order of the programs, you could use the "Program Edit" function to change(see
page 15).
1. Press VOL+/- to adjust the volume.
2. If you want to switch the sound OFF, press the MUTE
3. You can cancel this function by pressing MUTE or VOL+ button.
1. Using the CH+/- on the front panel or CH+/- on the remote control.
Press CH+ to increase channel number.
Press CH- to decrease channel number.
2. Using 0-9 digital buttons and -/-- button
Press -/-- button, then the screen will display "-", press again it will become "- -".
When it displays "-", you should then press a unmber of 0-9 to play the channel you desired;
When it displays "- -", you should then press two unmbers to play the channel you desired.
First time installation
Country
Language
Delete Analog Program
Analog Program Search
First Time Installation
English
Cancel
OK
Select
Adjust
UK
8