Computherm Q3RF Operating Instructions Manual page 7

aggressive or dusty environment. Its optimal location is 0.75-
1.5 m above floor level. It can be placed on its own stand or
can be mounted on a wall.
IMPORTANT WARNING! If the radiator valves in your flat
are equipped with a thermostatic head, adjust it to maximum
temperature or replace the thermostatic head of the radiator
valve with a manual control knob in the room where the room
thermostat is to be located, otherwise the thermostatic head
may disturb the temperature control of the flat.
2. PUTTING THE THERMOSTAT INTO
OPERATION
To put the thermostat into operation, detach the rear panel of
the thermostat from the front panel
by pressing the lock on the upper
side of the housing of the thermos-
tat, as shown in the figure.
The battery compartment is in
the inner side of the front panel of
- 7 -