Computherm Q3RF Operating Instructions Manual page 12

3.4 Calibration of the thermometer of the thermostat
You can calibrate the thermometer of the appliance (to cor-
rect measured temperature). To this end all you have to do is
change the position of the orange-colored potentiometer by a
Phillips screwdriver. When you adjust the potentiometer cloc-
kwise then the displayed temperature will be lower than that
measured initially, and when you adjust it anticlockwise the
displayed temperature will be higher than that. The displayed
temperature can be adjusted within a range of approx. ±4 °C.
Correction of the displayed temperature takes place a few
seconds after the adjustment.
ATTENTION! If the modification of the basic settings was
done after inserting the batteries and the modifications did
not take effect, please press the "RESET" button located on
the main panel of the thermostat.
- 12 -