Table of Contents
Advertisement
I N S TA L L AT I O N
FLAMMABLE MATERIAL WARNING
Keep fixture minimum 5.0 feet (1.5m) away from flammable materials and/or
pyrotechnics.
ELECTRICAL CONNECTIONS
A qualified electrician should be used for all electrical connections and/or installations.
MINIMUM DISTANCE TO OBJECTS/SURFACES IS 6.6 FEET (2 METERS).
MINIMUM DISTANCE OF FLAMMABLE MATERIALS FROM THE SURFACE IS 1.6
FEET (0.5 METER)
DO NOT INSTALL THE FIXTURE IF YOU ARE NOT QUALIFIED TO DO SO!
•
Fixture MUST be installed following all local, national, and country commercial electrical and
construction codes and regulations.
•
Before rigging/mounting a single fixture or multiple fixtures to any metal truss/structure or placing
the fixture(s) on any surface, a professional equipment installer MUST be consulted to determine
if the metal truss/structure or surface is properly certified to safely hold the combined weight of the
fixture(s), clamps, cables, and accessories.
•
Ambient operating temperature range is
when ambient temperature falls outside of this range!
•
Fixture(s) should be installed outside walking paths, seating areas, or areas were unauthorized
personnel might reach the fixture by hand.
•
NEVER stand directly below the fixture(s) when rigging, removing, or servicing.
•
Overhead fixture installation must always be secured with a secondary safety attachment, such as
an appropriately rated safety cable.
•
Allow approximately 60 minutes for the fixture to cool down before servicing.
NOTE: THIS FIXTURE IS INTENDED FOR TEMPORARY OUTDOOR USE ONLY!
RIGGING
Overhead rigging requires extensive experience, including calculating working load limits,
knowledge about installation materials being used, and periodic safety inspection of all
installation material and the fixture, among other skills. If you lack these qualifications, do not
attempt the installation yourself. Improper installation can result in bodily injury.
-4°F to 113°F (-20°C TO 45°C).
12
Do not operate the fixture
Advertisement
Table of Contents
