Advertisement
MATRIX V
EM Marine 125KHz RFID / UHF 433.92 MHz reader with connection
via iButton (1-Wire) / Wiegand-26 / RS-485 protocols
1.
OVERVIEW
Matrix V reader
is used in Access Control Systems (ACS) to:
- read the serial numbers of various EM-Marine tokens (cards, key fobs etc.) operating on 125 kHz
frequency,
- accept the radio signals of KeeLoq tokens operating at 433,92 MHz frequency,
- transmit the acquired information to the controller using iButton (Dallas Touch Memory),
Wiegand-26 or RS-485 standard.
2.
SPECIAL FEATURES
Improved EM-Marine cards reading distance up to 50 cm.
Ability to read the codes off the radio key fobs based on HCS-300 chip, operating using KeeLoq
standard on 433,92 MHz frequency.
Reader casing is moisture-proof.
RS-485 output allowing to connect the reader to a remote PC via Z-397
very large distances (up to 1,200 m).
Each reader has a unique serial number required during its firmware update by the user.
3.
MOUNTING AND CONNECTION
The reader should be mounted on a flat surface protected from direct sunlight and precipitation,
allowing for easy access by a proximity card.
MATRIX V
User Manual
225 mm
170 mm
Figure 1.Dimensions.
www.ironlogic.me
series
converter across
36 mm
page 1
Advertisement
Table of Contents
Related Manuals for ironLogic Matrix V
Summary of Contents for ironLogic Matrix V
- Page 1 (1-Wire) / Wiegand-26 / RS-485 protocols User Manual OVERVIEW Matrix V reader is used in Access Control Systems (ACS) to: - read the serial numbers of various EM-Marine tokens (cards, key fobs etc.) operating on 125 kHz frequency,...
- Page 2 MATRIX V www.ironlogic.me To mount a MATRIX V reader perform the following steps: - Mark and drill the mounting holes of the same size as the holes in the reader casing; (Figure 1); - Connect the wires per Figures 2, 3, 4, 5.
- Page 3 MATRIX V www.ironlogic.me Jumperneeds to be cut to disable the reader sound. Cable 1(7 wires): - provides power for the device; - provides iButton (Dallas TM) and Wiegand-26 outputs; - used for external LED and sound control. Cable 2(4 wires): provides RS-485 output.
- Page 4 MATRIX V www.ironlogic.me Wiegand DATA0 DATA0 Common Common DATA1 DATA1 iButton (DS1990A emulation) DATA0 Common Common RS-485 Z-397 DATA1 Ainput iButton (One-time transmission) Binput Aoutput DATA0 Boutput 120 Om Common Common Converter DATA1 Figure 4.Choosing the transmission protocol Figure 5. Connection scheme via RS-485.
- Page 5 MATRIX V www.ironlogic.me 7. OPERATING CONDITIONS Ambient temperature: … °C 4 0°C Humidity: Not exceeding 80% at 25°C The reader should not be operated where the following exists: atmospheric precipitation, direct sunlight, sand, dust and moisture condensation. Reader specifications may not fully be as specified, when operating under non-recommended conditions.
Need help?
Do you have a question about the Matrix V and is the answer not in the manual?
Questions and answers