Configuring The Sonicwall Homeport; Homeport In Nat Mode - SonicWALL TELE3 TZ Getting Started Manual

3 Configuring the SonicWALL HomePort

After configuring your work computer on the WorkPort, you must configure your home
computer to be on the same subnet as the HomePort. Once you configure your home computer
on the HomePort, you can access the Internet through the TELE3 TZ or TELE3 TZX.

HomePort in NAT Mode

Using HomePort in NAT mode allows you to use a single, public IP address for all traffic on
the network. It is used to hide your IP address from users on the Internet. Configure the
HomePort in NAT mode using the following instructions:
1. Log into the Management interface from the WorkPort PC using a Web browser and the
WorkPort IP address configured for the TELE3 TZ or TELE3 TZX.
2. Click Advanced, and then HomePort.
3. Select HomePort in NAT Mode, and click Update for the configuration to take effect on
the TELE TZ.
The HomePort Private Address must be used when you configure your home PC IP address.
It should be used as the Default Gateway address in your TCP/IP settings.
SonicWALL Telecommuter's Guide to Getting Connected Page 19