Configuring Computers On The Workport - SonicWALL TELE3 TZ Getting Started Manual

Configuring Computers on the WorkPort

While the SonicWALL is restarting, two windows appear: one with the administrator login
10
prompt, and the second with instructions for configuring your computers on your network
(WorkPort). Minimize the login window to view and print the Installation Wizard instructions.
Complete either
DHCP Server Enabled
A
If you enabled the SonicWALL DHCP server, a screen is displayed with instructions to
configure computers on your network.
After the SonicWALL has restarted, change the network settings on the computers on the WorkPort.
Each computer must be configured to get its IP address dynamically.
You may need to restart the computers on your WorkPort to update the network settings. The
SonicWALL is now functioning and protecting your WorkPort from Internet-based attacks and
break-ins.
A or B depending on the configuration selected during installation.
On a Windows 2000 computer, do the following:
1. From the Start menu, select Settings.
2. Then select Network and Dial-up
Connections.
3. Right click on the Local Area Connection
icon, and then select Properties.
4. Click Internet Protocol (TCP/IP) and then
Properties.
5. Click Obtain IP address automatically.
6. You can select Obtain DNS server address
automatically or enter IP addresses of the
DNS servers.
7. Click OK, then OK again to close the
Properties window.
rint this screen. You need it to
P
!
properly configure the computers
on your network.
SonicWALL Telecommuter's Getting Started Guide Page 17