Access Control; Overview; Configure Access Control - Tenda W15-Pro User Manual

6.6

Access Control

6.6.1

Overview

The access control function enables you to allow or disallow the wireless devices to access the
wireless network of the AP based on their MAC addresses.
To access the page, choose Wireless > Access Control.
The AP supports the following two filter modes:
− Whitelist: It indicates that only the wireless devices with the specified MAC addresses
can access the wireless networks of the AP.
Blacklist: It indicates that only the wireless devices with the specified MAC addresses
−
cannot access the wireless networks of the AP.
6.6.2

Configure Access Control

Choose Wireless > Access Control. Select a wireless network radio band on which access
Step 1
control is to be implemented.
From the SSID drop-down list box, select an SSID of the wireless network to which the
Step 2
rule applies.
Enable Access Control.
Step 3
Set Mode to Blacklist or Whitelist.
Step 4
Enter the MAC address of the wireless device to which the rule applies. Then click Add.
Step 5
If the wireless device to be controlled has connected to the AP, click Add Online Devices to quickly add
the MAC address of the device to the access control client list.
63
Document version: V1.0