1
Login and Logout
1.1
Login
Use an Ethernet cable to connect a management computer to the AP or a switch
Step 1
connected to the AP.
Set the IP address of the computer to the same network segment as that of the AP.
Step 2
For example, if the IP address of the AP is 192.168.0.254, you can set the IP address of
the computer to 192.168.0.X (X ranges from 2 to 253 and is not occupied by other
devices) and subnet mask to 255.255.255.0.
The following figure takes 192.168.0.10 as an example.
1
Document version: V1.0