Related Manuals for ESX VN940-4G
Summary of Contents for ESX VN940-4G
- Page 1 VN940-4G SMART NAVICEIVER MOBILE INTERNET READY ™ V I S I O N A N D R O I D S E R I E S...
-
Page 2: Important Notes
IMPORTANT NOTES This guide is an aid for the professional installation of the device. Please note the following notes before installation: • Always handle all parts of the device and the components of your vehicle with care. • Under all circumstances observe the regulations of the vehicle manufacturer and do not make any changes to the vehicle which could impair driving safety. - Page 3 Lay the supplied cable sets and antennas in the vehicle. Please note the information on the next page. Then connect all cable sets, antennas and dongles to the ESX main device as described on page 6. Then plug in the cable plug from the radio slot of the vehicle on the ESX main unit or on its vehicle-specific system cable set.
-
Page 4: Scope Of Delivery
SCOPE OF DELIVERY ITEM FIGURE QUANTITY Main device ISO system cable set (20-pin connector) AV cable set 1 with audio and video connections incl. rear view camera (14-pin connector) USB port 1 (4-pin connector) 4G/LTE dongle (6-pin connector) USB port 2 (8-pin connector) Camera cable set for HD rear view camera... - Page 5 SCOPE OF DELIVERY ITEM FIGURE QUANTITY AV cable set 2 with power, audio and video connections, additional camera input (8-pin connector) External microphone (6-pin connector) GPS antenna DAB antenna 4G/LTE antenna VNA-LFB-FD6 Adapter for analog steering wheel remote control (Only VNC940-DBJ-4G and VNC945-DBJ-4G)
- Page 6 WIRING DIAGRAM GPS antenna WiFi antenna Fuse 10A DAB antenna 4G/LTE antenna 20-pin system socket Inputs for AV cable sets Radio antenna (F can be assigned for later accessories) Assignment system socket System cable set 1 (20-pin connector, black) Connection for handbrake signal (ground) Cable brown (BRAKE): Connection for reverse gear signal (+ 12V) Cable pink (BACK):...
-
Page 7: Wiring Diagram
WIRING DIAGRAM Assignment of AV connections AV cable set 1 (14-pin connector, black) Audio output Front/Left RCA white (FL): Audio output Front/Right RCA red (FR): Audio output Rear/Left RCA white (RL): Audio output Rear/Right RCA red (RR): Audio output Subwoofer RCA green (SUB WOOFER): Video output for external monitor 1 RCA yellow (VIDEO OUT 1):... - Page 8 GENERAL INSTALLATION INSTRUCTIONS GPS antenna The GPS antenna must be glued horizontally to the front of the dash- Remove the film on board. No reception is possible if the window is metallized. Choose the underside of the a flat spot with a clear view of the sky. The location must be about GPS antenna 50 cm away from the main unit, otherwise the GPS measurement accuracy will be reduced.
- Page 9 SETUP THE 4G/LTE INTERNET CONNECTION First lay the two 4G/LTE antennas inside the dashboard towards the windshield, one antenna for the left and one for the right. Ideally, you should stick the antennas to the windshield to ensure optimal recep- tion.
- Page 10 SETUP THE 4G/LTE INTERNET CONNECTION Then turn on the device to test the 4G/LTE connection. After the device has started, enter After successful entry, the SIM card is your 4-digit PIN code of the SIM card unlocked. here. Confirm the entry with the tick. If the device is successfully connect- If the device is turned off, you have ed to the mobile Internet, the „LTE“...
- Page 11 TECHNICAL DATA / RADIO SYSTEM TYPE Function Band Information Frequency Range Max. emitted power GLONASS 1.575MHz / 1.602 MHz – AM Radio Medium wave 520 - 1.700 Hz – FM Radio Band II 87,5 - 108 MHz – DAB Radio Band III (5A –...
- Page 12 ESX Car Media Systems · Audio Design GmbH Am Breilingsweg 3 · D-76709 Kronau/Germany Tel. +49 7253 - 9465-0 · Fax +49 7253 - 946510 www.esxnavi.de - www.audiodesign.de © All rights reserved. Subject to technical changes and errors.