Page 1
C O M M U N I C A T I O N S Installation & Operations Manual Emergency Call Station with 900MHZ 2100-CS9 Series RP8500CS9 Ver 1 N56 W24720 N. Corporate Circle Sussex, WI 53089 11/10 Made in the USA 866-850-8854 262-246-4828 (fax) www.rathsecurity.com...
Thank you for purchasing the Rath Emergency Call Station. We take great pride in our products, our service and support. Our #1 mission is customer satisfaction. When evaluating emergency communication systems, you can rely on Rath to continually provide Innovative Thinking, Design and Value.
9. Cable ties Call Station Installation: Rath recommends that the call station be mounted so that the push button is less than 48 inches above the ground to comply with the Americans with Disabilities (ADA) requirements. For ease of installation, two people should perform the install.
Solar Panel and Antenna Installation: Solar Panel Clamps 1. Identify a location that will allow the solar panel to collect maximum light with minimal amount of shade. The panel must face directly south. 2. Mount the solar panel bracket to the wall or pole with the two supplied hose clamps or screws (not provided).
900 MHz Base Station Installation: 1. Set base station in the planned location. 2. Assemble the antenna to the magnetic base. 3. Attach the antenna to the base station at the connection marked ANT. 4. Attach the supplied cable into the TEL port of the base station and connect to an analog phone jack. 5.
Page 6
Programming of the Phone (continued): Remote: Step 1. Begin Program mode A. Call into phone by dialing the number the line is on. B. After 1st simulated ring Press #, # (Wait for 4 tones) C. Key in security code (default is 1111) (Wait for confirmation tones) Step 2.
Called Party Hang-up Instructions Depending on the Phone System, it may take some time for the Rath emergency phone to hang-up. To force the Rath phone to hang-up immediately, the called party should press * then # before hanging up.
Troubleshooting: Problem Possible Cause & Fixes • Check to make sure the phone line connected. No dial tone when the button is pushed: • Speaker control needs to be adjusted. Go to Speaker Adjustment on page 6. Audio is low from the speaker: •...
Page 9
2100-CS9 Series Emergency Call Station Dimensional Specifications: Call Station Body of Call Station 2100-CS9 Height 36 in. Width 10 in. Depth 8 in. Thickness of Steel 18 Gauge Total Weight of Steel: 51 lbs. pg. 8 E M E R G E N C Y...
Page 10
This Warranty statement of policy is in lieu of any other policy expressed or implied and no representative or person is authorized to assume any other liability or adopt any other policy for Rath without our written consent.
Need help?
Do you have a question about the 2100-CS9 Series and is the answer not in the manual?
Questions and answers