Mounting - Alpine NVE-N099P Manual

4. Mounting

Note:
The main unit must be mounted within ±5 degrees of the
horizontal plane, left to right, and 30 degrees of the
horizontal plane, back to front.
Less than 30°
a When mounting using Velcro fastener
1
Place Velcro fasteners.
Place two pieces of Velcro fasteners onto the
mounting surface. The rough side should be
facing the navigation unit.
2
Press the Navigation unit onto the Velcro
fastener at the mounting position.
Remove the backing to the adhesive on the
Velcro strips. Press the Navigation unit onto the
mounting location.
Continued to the step 5 "Securing leads, etc."
Velcro fasteners
a When mounting on the rear tray
1
Mount the brackets 1 on the unit.
Mount the brackets at both sides of the unit with
screws with double washer (M4×8) 3.
3
(Bottom side)
Depending on the
locations of the
mounting screw holes,
the mounting brackets
(for the left and right)
can be used on either
side.
2
a When mounting the unit directly on
1
Floor
2
1
3
Attach the unit on the rear tray.
Attach the unit securely with hex bolts (M6×50)
4, flanged hex nuts (M6) 7, spring washers
(M6) 6, and wing nuts (M6) 8.
Continued to step 5 "Securing leads, etc."
(Bottom
side)
the floor
Mount the brackets 1 on the unit.
Mount the brackets at both sides of the unit with
screws with double washer (M4×8) 3.
1
3
Mount the unit on the floor.
Mount the unit on the floor with flanged self-
tapping screws (M5×15) 5 and spring washers
(M6) 6.
Warning: Do not damage pipe or wiring when
drilling holes.
Continued to step 5 "Securing leads, etc."
4
7
6
8
Depending on the
locations of the mounting
screw holes, the mounting
brackets (for the left and
right) can be used on
either side.
1
3
5
6
11