Attach Legs - Inspired Flight IF1200 Setup Manual

2

ATTACH LEGS

STEP 1: Remove the landing gear located in the wide slots within
the drone case.
STEP 2: Locate the two sections of landing gear. The shorter piece
(with rubber caps) are the "feet" of the drone, while the
longer tubes are the "legs."
STEP 3: Loosen the clamp on the shorter piece (feet).
STEP 4: Insert the longer tube (legs) perpendicularly into the
shorter tube (feet).
STEP 5: Tighten the clamp by twisting the lever until fully tightened.
(Repeat steps 1-5 again for the other landing gear)
STEP 6:
Unfold the two arms that are located next to the leg insert
slots on the drone.
STEP 7: Insert the leg into the drone body, ensure the notch at the end of
the tube aligns with the key inside the corresponding socket.
STEP 8: Fully secure the leg by twisting the lever until it is fully tightened.
STEP 9: Ensure the o-rings are on the lower half of the tube assembly,
closer to the feet.
STEP 10: The tightening lever can be repositioned to a convenient
position by pulling it outward and rotating it.
3