Burner Removal; Brick Panel Removal; Porcelain Panel Removal; Media Tray Removal (Glass Only) - Napoleon STARfire Series Installation And Operation Manual

maintenance
EN
10.3

burner removal

Remove any media and/or media tray from the applaince, refer to "MEDIA TRAY REMOVAL" section.
A.
Remove the screws from the burner assembly base and carefully lift from the firebox.
B.
10.4

brick panel removal

Remove the 2 screws securing the brick panel brackets from the top left of the appliance. Remove the
A.
screws securing the front brick retainers.
Remove the left panel. NOTE: Care must be taken with the rear panel as it rests against the left
B.
and right panels.
Repeat step (A) for the right side.
C.
Remove the rear panel by lifting it up and out of the rear panel support.
D.

10.5 porcelain panel removal

Remove the 4 securing screws from the top / bottom left of the panel inside the firebox, remove the
A.
panel.
Repeat on the right side.
B.
Remove the 4 securing screws from the top and bottom of the rear panel and remove.
C.

10.6 media tray removal (glass only)

Vacuum the media from the appliance.
A.
Remove the 4 securing screws from the burner media tray and lift up and out, refer to Figure 1.
B.
Carefully lift the bottom media tray from the appliance, refer to Figure 2.
C.
Fig. 1
50
W415-2372 / B / 12.09.20
Fig. 2