Netopia R3100-U User Reference Manual page 133

Press the Escape key when you are finished configuring Exported Services to go back to the IP Setup
screen.
Ethernet IP Address:
Ethernet Subnet Mask:
Default IP Gateway:
DNS Server:
Secondary DNS Server:
Domain Name:
Receive RIP:
Transmit RIP:
Static Routes...
Set up the basic IP attributes of your Netopia in this screen.
Follow these steps to configure IP Setup for your Netopia R3100:
Select Ethernet IP Address and enter the IP address for the Netopia R3100's Ethernet port.
Select Ethernet Subnet Mask and enter the subnet mask for the Ethernet IP Address that you entered in
the last step.
Select Default IP Gateway and enter the IP address for a default gateway. This can be the address of any
major router accessible to the Netopia R3100 such as 127.0.0.2.
A default gateway should be able to successfully route packets when the Netopia R3100 cannot recognize
the intended recipient's IP address. A typical example of a default gateway is the a corporate dial-in or
ISP's router.
Select DNS Server and enter the IP address for a domain name server. The domain name server matches
the alphabetic addresses favored by people (for example, www.netopia.com) to the IP addresses actually
used by IP routers (for example, 163.7.8.202).
If a secondary DNS server is available, select Secondary DNS Server and enter its IP address. The
secondary DNS server is used by the Netopia R3100 when the primary DNS server is inaccessible.
Entering a secondary DNS is useful but it is not necessary.
Select Domain Name and enter your network's domain name (for example, netopia.com). Entering a
Domain Name is strongly recommended.
Routing Information Protocol (RIP) is needed if there are IP routers on other segments of your Ethernet
network that the Netopia R3100 needs to recognize. Set to "Both" (the default) the Netopia R3100 will
accept information from either RIP v1 or v2 routers. Alternatively, select Receive RIP and select v1 or v2
from the popup menu. With Receive RIP set to "v1," the Netopia R3100's Ethernet port will accept routing
information provided by RIP packets from other routers that use the same subnet mask. Set to "v2," the
IP Setup and Network Address Translation 11-9
IP Setup
192.168.6.137
255.255.255.248
0.0.0.0
0.0.0.0
0.0.0.0
Both
Off