Quick Easy Setup Connection Path - Netopia 4753 2A4NA Administration Manual

Quick Easy Setup Connection Path

This section may be all you need to do to configure your Netopia 4753 G.SHDSL Integrated Access Device to
connect to the Internet.
Your service provider must supply you with several parameter values for you to enter in the device. The service
provider will provide values for the parameters shown below:
Parameter:
Regional Setting
Data Link Encapsulation
PPP Mode
RFC1483 Mode
PPP over Ethernet (PPPoE)
(for Bridged 1483 only)
Data Circuit VPI
Data Circuit VPI
(for ATM WAN DSL Mode only)
Voice Gateway
Voice VPI
Voice VCI
(for any Voice Gateway other
than TollBridge)
Address Translation Enabled
IP Addressing
Local WAN IP Address
Local WAN IP Mask
Remote IP Address
Remote IP Mask
PPP Authentication
User Name (or Host Name)
Default value:
DSL Line Configuration Screen
Annex A (default) or Annex B
PPP or RFC1483 (default)
VC Multiplexed (default) or
LLC SNAP
Bridged 1483 (default)
or Routed 1483
Off (default) or On
0-255 (8 is default)
0-65535 (35 is default)
Voice Easy Setup Screen
CopperCom,
JetStream,
TollBridge,
TDSoft
or Zhone
0-255 (0 is default)
0-65535 (0 is default)
Easy Setup Profile Screen
Yes (default) or No
Unnumbered or Numbered
(default)
n/a
n/a
None (default), PAP or CHAP
n/a
Easy Setup 7-3
Your value: