Netopia 3341-ENT Firmware User Manual page 90
Enterprise-series netopia firmware version 8.7
Hide thumbs
Also See for 3341-ENT:
- Getting started manual (40 pages) ,
- Specifications (2 pages) ,
- Specification sheet (2 pages)
Table of Contents
Advertisement
3-46 Firmware User Guide
33. PPPOE: PADS Received
34. PPPOE: PADT Received
35. PPPOE: PADT Sent
36. PPPOE: Discovery state started profile [Profile Name]
37. PPPOE: Session state started profile [Profile Name]
38. PPPoE: Auth. Failed with Server: [Server]
39. PPTP: IP up, rem: [IP Address], via: [IP Address] tunnel id: [ID]
40. PPTP: IP down, rem: [IP Address] tunnel id: [ID]
41. IPsec: VPN installed:profile: [Name], spi: [SPI], rem sg: [IP Address]
42. IPsec: VPN fail: profile: [Name]
43. IPsec: VPN removed: profile: [Name], spi: [SPI], rem sg: [IP Address]
44. IPsec: tx: spi not found, profile [Name]
45. IPsec: tx: no remote sg, profile [Name]
46. IPsec: tx: local vpn, profile [Name], spi [SPI], src [IP Address]
47. IPsec: tx: remote vpn, profile [Name], spi [SPI], dest [IP Address]
48. IPsec: tx: remote route, profile [Name], spi [SPI], sg [IP Address]
49. IPsec: tx: local addr, profile [Name], spi [SPI], sg [IP Address]
50. IPsec: rx: spi mismatch, profile [Name], spi [SPI], sg [IP Address]
51. IPsec: rx: auth fail, profile [Name], spi [SPI], sg [IP Address]
52. IPsec: rx: crypt fail, profile [Name], spi [SPI], sg [IP Address]
53. IPsec: rx: spi not found, protocol [Prot], spi [SPI], sg [IP Address]
54. IPsec: rx: sg mismatch, profile [Name], spi [SPI], sg [IP Address]
55. IPsec: rx: sa proto, profile [Name], spi [SPI], sg [IP Address]
56. IPsec: rx: unknown protocol, profile [Name], spi [SPI], sg [IP Address]
57. IPsec: rx: vpn host accepted, profile [Name], spi [SPI], sg [IP Address]
58. IPsec: rx: vpn host rejected, profile [Name], spi [SPI], sg [IP Address]
59. IPcomp: compression failure, profile [Name], spi [SPI], sg [IP Address]
60. IPcomp rx: IPcomp mismatch?, profile [Name], spi [SPI], sg [IP Address]
61. Last message repeated [Num.] times
62. IKE: no ph1 preferences assigned, sg [IP Address]
63. IKE: DNS lookup failure, profile [Name]
64. IKE: no matching ph1 profile: sg [IP Address]
65. IKE: no matching ph1 proposal sg [IP Address] profile [Name], sg [IP Address]
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 3341-ENT and is the answer not in the manual?