Pedals; Battery - Gio Electric WISP Owner's Manual

Pedals

Begin pedal installation by correctly matching the corresponding pedal to
each side of the eScooter. (Pedals are labeled) Twist pedal into place and
tighten into place with the open ended wrench, in the following directions;
left pedal tighten counterclockwise, right pedal tighten clockwise.
(Recommended 40NM)
Battery Connection
Remove the 4 bolts holding the footboard in place and carefully set aside.
Lift off the foot board to reveal the battery compartment. Locate the
disconnected battery wires ensuring to reconnect positive red to positive
red and negative black to negative black. Replace the footboard and bolts,
you are now ready to charge your eScooter.
⚠
PLEASE NOTE YOUR WISP ESCOOTER DOES NOT ARRIVE FULLY CHARGED
AND MUST BE CHARGED COMPLETELY BEFORE FIRST USE.
7