Advertisement
Table 2 Installation hole spacing for each model
Chassis
HPE 1405 5G v3 Switch
HPE 1405 8G v3 Switch
To install the switch on a wall:
1.
Drill two holes at the same height.
2.
Insert one wall anchor into each hole until the anchors are flush
with the wall surface. Drive one screw into each wall anchor,
and then tighten the screws just enough to keep it secure in the
wall anchor.
3.
Align the two mounting holes in the switch chassis bottom with
the two screws on the wall and hang the switch.
Installation hole spacing
74 mm (2.91 in)
102 mm (4.02 in)
3
Advertisement
