Connect The Sc101 To Your Network; Next, Install The Sc101 Software; Before You Begin - NETGEAR SC101 Reference Manual

Connect the SC101 to Your Network

1. Connect the provided Ethernet cable to your network and to the back of the SC101. Be sure
your network is running. DHCP must be available in the network. DHCP is usually enabled on
home networks by default.
2. Plug in the power adapter to a power source and connect the other end to the SC101. View the
front panel to verify that the green power light is on and that the yellow network light is on.

Next, Install the SC101 Software

Before You Begin

• Your PC must be connected to the same network as the Storage Central unit during the
software installation. You can connect the PC via Ethernet, or if you have a wireless network,
your PC can be connected to the network wirelessly.
• You will need to install this software on each PC that will access the Storage Central
1. Insert the NETGEAR CD into your PC and the Smart Wizard screen opens.
Figure 3-8
If the Smart Wizard screen does not appear, run Autorun.exe on the CD.
Reference Manual for the NETGEAR Storage Central SC101
v1.0, September 2005
3-5