Install The Hard Disk - NETGEAR SC101 Reference Manual

Install the Hard Disk

Warning: Be sure to unplug the power cord from the SC101 before adding or removing
the disks. Failure to observe this precaution could render your disks useless.
Follow the steps below to install an IDE hard disk drive into you SC101.
1. Remove the cover.
a. Use a coin or screwdriver to
open the spring loaded cover
lock by turning it clockwise.
b. Remove the cover.
2. Insert the hard disk.
a. Position the hard disk so that
the D-shaped power socket is
on the top.
b. Slide the hard disk into either
slot.
Reference Manual for the NETGEAR Storage Central SC101
v1.0, September 2005
Figure 3-4
D-shaped
power socket
Figure 3-5
3-3