Table of Contents
Advertisement
3.
Attaching New Speaker Mesh
When ordered through Daktronics, the mesh has a line with a series of tick marks
printed on the front (Figure 16). These tick marks are used to indicate the location of
the tension clips and mandrels.
Figure 16: Tick Marks on Mesh
a.
b. Fold the mesh around the mandrel. Ensure the groove in the mandrel is
c.
d. Continue to place a mandrel and tension clip on every tick mark.
12
Place a mandrel, smooth side up, centered on the tick mark.
towards the inside of the mesh (Figure 17).
Figure 17: Folding Mesh
Snap a tension clip over the mandrel and mesh (Figure 18). Do not try to
drive both ends of the clip down onto the mandrel and fabric at the same
time; snap one end down and then the other.
Figure 18: Attach Tension Clip
Maintenance & Troubleshooting
Advertisement
Table of Contents
Troubleshooting
