LEDs
The table below describes the activity of the LEDs.
Label
Color
Pwr (Power)
Green
Col (collision)
Amber Blinking Data collision is occurring on the network. Note
Link
Green
(located on the
top left corner of
each vista
10BASE-T port)
Rx
Green
(located on the
top right corner
of each vista
10BASE-T port)
Normal/Uplink Push Button
The Normal/Uplink push button allows you to select Normal (MDI-X) wiring
for direct PC connection. The push button also allows you to select Uplink
(MDI) wiring for connection to a hub or a switch through port 4 on the Model
TP
EN104
hub, port 6 on the Model EN106
TP
EN108
hub. This uplink configuration eliminates the need to use a crossover
cable. The other 10BASE-T ports are permanently configured for normal wiring
for connection to a PC.
Rear Panel
The rear panel of the hub has a ground clip and a receptacle for the power
adapter.
TP
Model EN104
/EN106
Activity Description
On
Power is supplied to the hub.
that occasional collisions are normal.
On
The link between this port and the connected
device is good.
Blinking There is incoming data on the port.
TP
TP
TP
/EN108
Ethernet Hub Installation Guide
hub, or port 8 on the Model
Power
receptacle
5Vdc 800mA
–
+
8730FA