PaloAlto Networks ION 1200 Series Hardware Reference Manual page 84

Install ION 1200-S
STEP 6 | Plug the power supply connector into the back of the device. Using the provided tie-wraps,
bind and secure the power supply cable toward the back end of the tray using the sheet-
metal lances toward the center of the tray.
STEP 7 |
After assembling the device to the tray and connecting the power cable to the device, tie-
wrap the power cord to the "C" channel.
STEP 8 | With the front of the device facing forward, align the four rubber feet on the bottom of the
device to the slotted holes in the provided mounting tray. Secure the device in place using
two provided #6-32 x 3/16" Long Flathead screws.
STEP 9 | Slide the mounting tray into the rails previously fixed to the equipment rack. Stop when the
front flange on the mounting tray is flush with the front of the rail.
ION 1200 Hardware Reference
84
2022 Palo Alto Networks, Inc.
©