2-3.Connecting A Sas Device; 2-4.Installation Of The Driver - NEC N8103-197 User Manual

2-3.Connecting a SAS device

To connect a SAS device.


Notice


1. Confirm the power to the server is off, then unplug the power cord from the electrical outlet.

Notice
2. Insert a SAS cable connector in this product's connector fully for firm connection.
Insert a cable connector (the other side) in SAS device's connector fully for firm connection.
3.
4. Plug the power cord of the server into the electrical outlet.

2-4.Installation of the Driver

To use this product, the appropriate driver for your operating system must be installed. For detailed
information, refer to the user's guide of the server.
Do not install an operating system in the device connected to this product.
Do not use the RAID function of this product when connecting disk array device to
this product.
Do not connect this product to a server or SAS device that is not recommended by
NEC Corporation. If the product is connected to a server or SAS device that is not
recommended by NEC Corporation, the product may malfunction or fail.
Please contact the retailer or service center for the information on recommended
servers, SAS devices, or SAS cables.
If the power to the server is on, shut down the operating system and then turn off
the server.
- 27 -